GameCube

Models

insert data

Models Tested

PAL launch model (tested on OSSC).

XRGB-2 Specific Settings

insert data

XRGB-3 Specific Settings

insert data

XRGB-Mini Specific Settings

insert data

OSSC Specific Settings

No special settings are required.

Morph 4K Specific Settings

HDMI Compatible Devices:

• GCVideo Upgrade
  • GCDual (digital-to-digital)
    • StoneAgeGamer
    • Castlemania Games
    • Game-Tech
    • Arthrimus
• Digital Dongle (DOL-001 model)
  • Carby (digital-to-digital)
  • GCHD MK-II (digital & analog-to-digital)
    • Black
    • Indigo
    • Orange
    • Platinum

GCVideo

Note: GCVideo must be on firmware 3.1. If your device is using an older version of GCVideo, you can grab 3.1 firmware from here. For Carby, grab it here.

For GCDual:

1. Power on the GC, then press and hold the button combo L+R+X+Y to open the GCVideo menu.
2. Use Up+Down on directional pad and X+Y buttons (Back & Forward) to set the values below.
3. When finished, select Store Settings to save and then Exit.

For Carby:

1. Power on the GC, then with the included remote use either Menu or OK to open the GCVideo menu.
2. Use Up+Down+Left+Right arrows to navigate and set the values below.
3. When finished, select Store Settings to save and then Exit.

Output Settings:

Allow 480p Mode	On *
Crop 486 to 480	On
RGB Limited Range	On
Enhanced DVI Mode	On
Display as 16:9	Off

View All Modes:

240p	Linedoubler: Off
288p	Linedoubler: Off
480i	Linedoubler: Off
576i	Linedoubler: Off

Advanced Settings:

Chroma Interpolation	Off [or On] **
Fix Resolution	On
Fix Sync Timing	Off
Regenerate CSync	Off
Digital Color Format	YC422 [or YC444 / RGB-F / RGB-L] **
Report 240p as 480i	Off

* GameCube supports native 480p. When loading 480p-compatible games, make sure to hold down B to enable Progressive Mode.

** GameCube natively uses YCbCr 4:2:2 (Digital Color Format = YC422). If you prefer to use YC444 / RGB-F / RGB-L, then Chroma Interpolation must be On.