GameCube

Models

insert data

Models Tested

PAL launch model (tested on OSSC).

XRGB-2 Specific Settings

insert data

XRGB-3 Specific Settings

insert data

XRGB-Mini Specific Settings

insert data

OSSC Specific Settings

No special settings are required.

Morph 4K Specific Settings

HDMI Compatible Devices:

• GCVideo Upgrade
  • GCDual (digital-to-digital)
    • StoneAgeGamer
    • Castlemania Games
    • Game-Tech
    • Arthrimus
• Digital Dongle (DOL-001 model)
  • Carby (digital-to-digital)
  • GCHD MK-II (digital & analog-to-digital)
    • Black
    • Indigo
    • Orange
    • Platinum

GCVideo

Note: GCVideo must be on firmware 3.1. If your device is using an older version of GCVideo, you can grab 3.1 firmware from here. For Carby, grab it here. For details on GCVideo settings, see the README in the GitHub.

For GCDual:

1. Power on the GC, then press and hold the button combo L+R+X+Y to open the GCVideo menu.
2. Use Up+Down on directional pad and X+Y buttons (Back & Forward) to set the values below.
3. When finished, select Store Settings to save and then Exit.

For Carby:

1. Power on the GC, then with the included remote use either Menu or OK to open the GCVideo menu.
2. Use Up+Down+Left+Right arrows to navigate and set the values below.
3. When finished, select Store Settings to save and then Exit.

Output Settings:

Allow 480p Mode	On *
Crop 486 to 480	On
RGB Limited Range	On
Enhanced DVI Mode	On
Display as 16:9	Off

View All Modes:

240p	Linedoubler: Off
288p	Linedoubler: Off
480i	Linedoubler: Off
576i	Linedoubler: Off

Advanced Settings:

Chroma Interpolation	Off [or On] **
Fix Resolution	On
Fix Sync Timing	Off
Regenerate CSync	Off
Digital Color Format	YC422 [or YC444 / RGB-F / RGB-L] **
Report 240p as 480i	Off

* GameCube supports native 480p. When loading 480p-compatible games, make sure to hold down B to enable Progressive Mode.

** GameCube natively uses YCbCr 4:2:2 (Digital Color Format = YC422). If you prefer to use YC444 / RGB-F / RGB-L, then Chroma Interpolation must be On.